Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Engine

Starter Relay [Skyactiv G 2.0]
Purpose, Function The starter relay supplies power to the starter by receiving the signal from the PCM. Construction The starter relay is installed to the relay and fuse block. ...

General
...

Other materials:

Hood Release Cable Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front bumper. b. Front combination light (LH). c. Front mudguard (LH). d. Hood release lever. 3. Disconnect the hood release cable from the hood latch. 4. While pressing the tabs of the clip in the direction o ...

Rear Side Marker Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the service hole in the position shown in the figure. 3. Move the flathead screwdriver in the direction of the arrow (1) shown in the figure, pull out the service hole cover, and detach the serv ...

Front Fender Panel Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front bumper. b. Front combination light. c. Front bumper slider. d. Front over fender. 3. Remove bolts A and fasteners B. 4. Remove bolts C. 5. Remove the front fender panel. 6. Install in the reverse ...

© 2016-2026 Copyright www.mcx5.org