Mazda CX-5 Service & Repair Manual: Air Bag System Warning Alarm [Two Step Deployment Control System]
Purpose
-
The air bag system warning alarm notifies the driver that a malfunction occurred in the air bag system instead of the air bag system warning light.
Function
-
If a malfunction occurs in the air bag system while the air bag system warning light cannot illuminate, the air bag system warning alarm sounds.
Construction
-
The air bag system warning alarm sounds a buzzer in the instrument cluster.
Operation
-
The SAS control module sends the air bag system warning alarm trigger signal to the instrument cluster via CAN communication to sound the buzzer in the instrument cluster.
-
If all of the following conditions are met, the SAS control module sends the air bag system warning alarm trigger signal to the instrument cluster.
-
SAS control module detects DTC B00D2:29 (air bag system warning light (during communication related malfunction))
-
SAS control module detects DTCs other than DTC B00D2:29 (Except for air bag system warning light does not illuminate DTC)
-
Refer to the air bag system warning alarm for the air bag system warning alarm sound interval.
Fail-safe
-
Function not equipped.
Air Bag System Warning Alarm [Standard Deployment Control System]
Purpose
The air bag system warning alarm notifies the driver that a malfunction occurred
in the air bag system instead of the air bag system warning light.
Function
If a malfunc ...
Air Bag System Warning Light [Standard Deployment Control System]
Purpose
The air bag system warning light notifies the driver of a malfunction in
the SRS air bag system.
Function
If a malfunction occurs in the SRS air bag system, the air bag ...
Other materials:
Theft Deterrent Horn Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk end trim.
b. Rear scuff plate (RH).
c. Trunk side trim (RH).
d. Theft-deterrent horn.
3. Apply battery positive voltage to horn terminal A, and connect the horn retaining
bolt to ground as shown in the f ...
Clock Spring Removal/Installation [Two Step Deployment Control System]
CAUTION:
If the disc on the combination switch is deformed or has foreign material
adhering to it, performance of the steering angle sensor may be reduced, causing
abnormal operation. When handling the clock spring, be careful not to deform
the disc and make sure there is no foreign ...
Rear Drive Shaft Inspection
1. Inspect each connecting part for looseness.
Tighten or replace parts if necessary.
2. Inspect the dust boot on the drive shaft for cracks, damage, leaking grease,
and looseness in the boot band.
3. Inspect the drive shaft for bends, cracks, and wear in the joints or splines. ...
