Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Engine Coolant Temperature (ECT) Sensor Inspection

Mazda CX-5 Service & Repair Manual / Engine / Cooling / Engine Coolant Temperature (ECT) Sensor Inspection

Resistance Inspection

WARNING:

ECT Sensor No.1

1. Remove the ECT sensor No.1..

2. Place the ECT sensor No.1 in water with a thermometer, and heat the water gradually.


3. Measure the resistance between ECT sensor No.1 terminals A and B.


Specification


ECT (°C {°F})

Resistance (Kilohms)

20 {68}

Approx. 2.45

80 {176}

Approx. 0.318



ECT Sensor No.2

1. Remove the ECT sensor No.2..

2. Place the ECT sensor No.2 in water with a thermometer, and heat the water gradually.


3. Measure the resistance between ECT sensor No.2 terminals A and B.


Specification


ECT (°C {°F})

Resistance (Kilohms)

20 {68}

Approx. 2.45

80 {176}

Approx. 0.318



Engine Coolant Replacement
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may ...

Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Disconnect the negative battery c ...

Other materials:

Coupler Component Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING: A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool. Always wear protective eye wear when using the air compressor. If the air compressor is used, any particles of dirt or soiling could spatter and get into the eyes. ...

Front Drive Shaft Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

Hydraulic Variable Valve Timing Actuator Inspection
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. CAUTION: Do not disassemble the hydraulic variable valve timing actuator because it is a precision unit. 1. Disconnect the negative battery cable.. 2. Rem ...

© 2016-2026 Copyright www.mcx5.org