Mazda CX-5 Service & Repair Manual: Cooling System

Mazda CX-5 Service & Repair Manual / Engine / Cooling / Cooling System

Outline

Passing water resistance is reduced by improvement of the engine coolant passage shape.
Pump efficiency is improved by changing the water pump impeller to the closed impeller.

Structural View

Flow Chart

Structure

Consists of the following parts:

Radiator	(See RADIATOR [SKYACTIV-G 2.0].)
Cooling system cap	(See COOLING SYSTEM CAP [SKYACTIV-G 2.0].)
Thermostat	(See THERMOSTAT [SKYACTIV-G 2.0].)
Water pump	(See WATER PUMP [SKYACTIV-G 2.0].)
Cooling fan component	(See COOLING FAN COMPONENT [SKYACTIV-G 2.0].)
Cooling fan relay	(See COOLING FAN RELAY [SKYACTIV-G 2.0].)

Cooling System Service Warnings

WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may ...

Electrical Fan Control

Outline Through cooling of the radiator and condenser by operation of the cooling fan according to vehicle conditions, engine reliability and cooling performance have been improved. ...

Other materials:

DSC Related Parts Sensor Initialization Procedure
WARNING: If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the initialization procedure to insure proper DSC ...

Driver Side Air Bag Module Removal/Installation [Standard Deployment Control System]
WARNING: Handling the air bag module improperly can accidentally deploy the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the air bag module.. NOTE: The driver-side air bag module is installed to the ...

Assist Handle Removal/Installation
Removal 1. Insert a tape-wrapped flathead screwdriver into the service hole and remove the assist handle covers. 2. Remove the assist handle in the direction of the arrow (1) and (2), while detach clips. NOTE: Remove the assist handle by shaking it up and down. Install ...