Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Fuel Pump Control Module Removal/Installation

Mazda CX-5 Service & Repair Manual / Engine / Fuel / Fuel Pump Control Module Removal/Installation

1. Disconnect the negative battery cable..

2. Tip the rear seat (LH).

3. Disconnect the clip connected to trunk board.

4. Disconnect the fuel pump control module connector.

5. Remove the fuel pump control module.


6. Install in the reverse order of removal.

Fuel Pump Control Module Inspection
1. Perform the KOEO self-test.. 2. Verify that a fuel pump control module related DTC is detected.. If DTCs are detected, repair the malfunctioning part according to the applicable DTC tr ...

Fuel Pump Control Module
Purpose, Function Controls the voltage applied to the fuel pump for reducing fuel pump load and improving fuel economy. Controls the voltage applied to the fuel pump based on the con ...

Other materials:

Cylinder Head Cover
Purpose, Function The cylinder head cover prevents foreign material penetration and engine oil spatter. The oil baffle plate reduces engine oil consumption by separating the engine oil from the blow-by gas. Construction The lightweight cylinder head cover is made of ...

Fuel Pump Unit
Purpose, Function Supplies fuel in the fuel tank to the high pressure fuel pump. Based on the control signal from the PCM, the fuel pump operates by the operation of the fuel pump relay and the fuel pump control module. Construction 2WD The fuel pump unit is installed ...

Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the trunk board.. 2. Remove the trunk end trim.. 3. Remove the rear scuff plate.. 4. Remove the trunk side trim.. 5. Disconnect the rear ABS wheel-speed sensor connector. 6. Press the rear ABS wheel-speed sensor tabs and press out the sensor toward the outside of the vehicl ...

© 2016-2026 Copyright www.mcx5.org