Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Canister Vent (Cv) Solenoid Valve Inspection

Mazda CX-5 Service & Repair Manual / Engine / Emissions / Canister Vent (Cv) Solenoid Valve Inspection

U.S.A. And CANADA

Airflow inspection

1. Disconnect the negative battery cable..

2. Remove the CV solenoid valve..

3. Inspect airflow between the ports under the following conditions.



Measured condition

Continuity between A—B

When voltage is not applied between terminals A and B

Airflow detected

When voltage is applied between terminals A and B

No airflow


Emissions
...

Canister Vent (Cv) Solenoid Valve Removal/Installation
U.S.A. And CANADA 1. Disconnect the negative battery cable.. 2. Remove the floor under cover (LH).. 3. Disconnect the evaporative hose No.2.. 4. Remove in the order indicated in the table. ...

Other materials:

Front Wheel Hub Bolt Replacement
1. Remove the brake calliper component from the steering knuckle and suspend it out of the way using a cable. 2. Remove the disc plate. 3. Remove the wheel hub bolt using the SST as shown in the figure. 4. Place a new wheel hub bolt in the wheel hub. 5. Install the wheel hub by placi ...

Wheel Alignment Pre Inspection
1. Park the vehicle on level ground, in an unloaded condition*, with the wheels straight forward. *: Unloaded condition.....Fuel tank is full. Engine coolant and engine oil are at specified level. Spare tire, jack and tools are in designated position. 2. Inspect the tire pressure. ...

Bumper Stiffener Lower Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Seal board upper. b. Front bumper. c. Seal plate. d. Front under cover No.1. 3. Remove bolts A. 4. Pull the bumper stiffener lower in the direction of the arrow (1), (2) shown in the figure, detach hooks ...

© 2016-2026 Copyright www.mcx5.org