Mazda CX-5 Service & Repair Manual: Manifold Absolute Pressure (Map) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Intake / Manifold Absolute Pressure (Map) Sensor

Purpose/Function

Detects the intake air pressure introduced into the cylinder as basic information for mainly determining the fuel injection amount.
Detects the intake air pressure introduced into the cylinder and inputs it to the PCM as an intake air pressure signal.

Construction

Installed on the intake manifold.
A sealant diaphragm has been adopted as the detecting element for detecting the intake air pressure.
IAT sensor No.2 is integrated.

Operation

Inputs the signal, which fluctuates according to the intake air pressure, to the PCM.

MAP sensor characteristic

Fail-safe


DTC No.	Fail-safe function
P0107:00	Estimates MAP using MAF sensor and engine speed. Restricts the upper limit of the engine speed. Inhibits the evaporative purge control.
P0108:00	Estimates MAP using MAF sensor and engine speed. Restricts the upper limit of the engine speed. Inhibits the evaporative purge control.

Manifold Absolute Pressure (Map) Sensor Inspection

Voltage Inspection 1. Connect the M-MDS to the DLC?2. 2. Switch the ignition ON (engine off or on). 3. Verify that the MAP sensor output voltage (PID: MAP) is within the specification.. ...

Manifold Absolute Pressure (Map) Sensor/Intake Air Temperature (Iat) Sensor No.2 Removal/Installation

NOTE: Because the IAT sensor No.2 is integrated in the MAP sensor, replacing the IAT sensor No.2 includes replacement of the MAP sensor/IAT sensor No.2. 1. Disconnect the negative bat ...

Other materials:

Front Door Key Cylinder Switch Inspection
1. Perform the front door glass preparation.. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inner garnish. b. Front door trim. c. Front door key cylinder. d. Front door glass. e. Front door module panel. f. Front door latch and lock actuator. Front Do ...

Fuel Tank Removal/Installation
WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring ...

Evaporator Temperature Sensor Inspection [Full Auto Air Conditioner]
NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed at MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULATE mode. 4. Turn the A/C switch off. 5. Close all doors and windows. 6. Wait for 5 min. 7 ...