Mazda CX-5 Service & Repair Manual: Intake Air System
Purpose, Outline
-
A vacuum pump has been adopted which supplies stable vacuum to the power brake unit.
Structural View
System Diagram
Vacuum Hose Routing Diagram
Structure
-
The intake air system consists of the following parts:
|
Part name |
Reference |
|
Fresh-air duct |
(See FRESH-AIR DUCT [SKYACTIV-G 2.0].) |
|
Resonance chamber |
(See RESONANCE CHAMBER [SKYACTIV-G 2.0].) |
|
Air cleaner |
(See AIR CLEANER [SKYACTIV-G 2.0].) |
|
Throttle body |
(See THROTTLE BODY [SKYACTIV-G 2.0].) |
|
Vacuum pump |
(See VACUUM PUMP [SKYACTIV-G 2.0].) |
|
Intake manifold |
(See INTAKE MANIFOLD [SKYACTIV-G 2.0].) |
|
Accelerator pedal |
(See ACCELERATOR PEDAL, KICKDOWN SWITCH [SKYACTIV-G 2.0].) |
Intake Air System Removal/Installation
WARNING:
A hot engine and intake air system can cause severe burns. Turn off the engine
and wait until they are cool before removing the intake air system.
1. Disconnect the negative ...
Intake Air Temperature (Iat) Sensor Inspection
IAT Sensor No.1
Resistance inspection
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No ...
Other materials:
Cargo Compartment Light Removal/Installation
1. Disconnect the negative battery cable..
2. To prevent scratches or damage, affix protective tape to the position shown
in the figure.
CAUTION:
If a flathead screwdriver is inserted into the gap between the cargo compartment
light and trunk side trim, the trunk side trim could int ...
Steering Angle Sensor
Purpose, Function
The steering angle sensor outputs the steering angle and steering angle reference
point during the period which the EPS control module performs initial learning
(approx. 1 min period).
Construction
The steering angle sensor is installed to the clock spring ...
Fuel Filler Lid Opener And Lever Removal/Installation
Fuel-filler Lid Opener
1. Open the fuel-filler lid.
2. Remove the nut.
3. Remove the service hole cover on the trunk side trim.
4. While pressing the tabs of the stopper bracket in the direction of arrow (1)
shown in the figure, press it in the direction of arrow (2) to detach it fr ...
