Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Engine Coolant Temperature (ECT) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Cooling / Engine Coolant Temperature (ECT) Sensor

Purpose/Function

Construction

ECT sensor No.1

ECT sensor No.2

Operation

ECT sensor characteristic


Fail-safe

ECT sensor No.1


DTC No.

Fail-safe function

P0117:00

  • Fixes the water temperature for the engine control at 40 °C {104 °F}, and for the idle air control at 80 °C {176 °F}.

  • Operates the cooling fan (high speed rotation).

  • Inhibits the fuel cut control during shift change.

P0118:00

  • Fixes the water temperature for the engine control at 40 °C {104 °F}, and for the idle air control at 80 °C {176 °F}.

  • Operates the cooling fan (high speed rotation).

  • Inhibits the fuel cut control during shift change.


ECT sensor No.2

Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Disconnect the negative battery c ...

Fan Switch Inspection [Manual Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Shift lever knob (MTX). b. Glove compartment. c. Front console box. d. Shift panel. e. Upper panel. f. Rear c ...

Other materials:

Air Bag System [Two Step Deployment Control System]
Outline The air bag system is a device that supplements the passenger restraint function of the seat belts. The air bag system will not have the designed effect if the seat belts are not worn properly. The air bag system is composed of the following parts: ...

Vacuum Pump Inspection
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump.. 2. Install the vacuum gauge as shown in the figure, then check the vacuum. 3. Warn up the engine. If the pressure is less than the specification, inspect for the following. Malf ...

Starter Cut Off Control [Skyactiv G 2.0]
Outline The PCM controls energization to the starter relay according to an immobilizer system request to improve security. While not in P or N position, the starter relay energization by the ignition key is inhibited. (ATX) While not in neutral, the starter relay energiz ...

© 2016-2026 Copyright www.mcx5.org