Mazda CX-5 Service & Repair Manual: Crankshaft Position (CKP) Sensor
Purpose/Function
-
Detects the crankshaft speed as basic information for mainly determining the fuel injection timing and ignition timing.
-
Detects the crankshaft speed and inputs it to the PCM as a CKP signal.
Construction
-
Installed on the side of the cylinder block (right side).
-
An MR (Magnetic Resistance) element has been adopted as the detecting element for detecting the crankshaft speed.
Operation
-
Inputs the signal, which fluctuates according to the crankshaft speed, to the PCM.
CKP sensor characteristic
Fail-safe
|
DTC No. |
Fail-safe function |
|
P0335:00 |
|
Crankshaft Position (CKP) Sensor Removal/Installation
CAUTION:
When foreign material such as an iron chip is on the CKP sensor, it can cause
abnormal output from the sensor because of flux turbulence and adversely affect
the engine control. ...
Engine Coolant Temperature (ECT) Sensor Inspection
Resistance Inspection
WARNING:
When the engine is hot, it can badly burn. Turn off the engine and wait until
it is cool before removing the ECT sensor.
ECT Sensor No.1
1. Remove the ...
Other materials:
Refrigerant Pressure Sensor Removal/Installation [Manual Air Conditioner]
1. Disconnect the negative battery cable..
2. Discharge the refrigerant..
3. Disconnect the refrigerant pressure sensor connector.
CAUTION:
If moisture or foreign material enters the refrigeration cycle, cooling ability
will be lowered and abnormal noise will occur. Always immediate ...
Hydraulic Variable Valve Timing Actuator
Purpose, Function
The hydraulic variable valve timing actuator operates according to the hydraulic
pressure and changes the phases of the exhaust camshaft. As a result, the open/close
period of the exhaust valve is changed, optimized valve timing in accordance
with driving conditions ...
Front Bumper Removal/Installation
CAUTION:
Affix the protective tape to the position (vehicle body side) shown in the
figure to prevent scratches and damage.
1. Disconnect the negative battery cable..
2. Remove fasteners A.
3. Pull the front over fender in the direction of the arrow shown in the figure ...
