Mazda CX-5 Service & Repair Manual: Emissions
- Canister Vent (Cv) Solenoid Valve Inspection
- Canister Vent (Cv) Solenoid Valve Removal/Installation
- Canister Vent (Cv) Solenoid Valve
- Catalytic Converter
- Catch Tank Inspection
- Catch Tank
- Charcoal Canister Inspection
- Charcoal Canister Removal/Installation
- Charcoal Canister
- Check Valve Inspection
- Check Valve Removal/Installation
- Check Valve
- Emission System
- Evaporative Emission (Evap) Control System
- Exhaust Gas Purification System
- Positive Crankcase Ventilation (PCV) System
- Positive Crankcase Ventilation (PCV) Valve Inspection
- Positive Crankcase Ventilation (PCV) Valve Removal/Installation
- Positive Crankcase Ventilation (PCV) Valve
- Purge Solenoid Valve Inspection
- Purge Solenoid Valve Removal/Installation
- Purge Solenoid Valve
- Quick Release Connector (Emission System) Removal/Installation
- Quick Release Connector (Emission System)
- Rollover Valve
- Warm Up Three Way Catalytic Converter (Wu Twc) Inspection
- Brake Fluid Pressure Sensor
- Brake Fluid Pressure Sensor Inspection
- Pressure Sensor Removal/Installation [Two Step Deployment Control System]
- Pressure Sensor [Two Step Deployment Control System]
- Refrigerant Pressure Sensor Inspection [Full Auto Air Conditioner]
- Refrigerant Pressure Sensor Removal/Installation [Full Auto Air Conditioner]
- Refrigerant Pressure Sensor Removal/Installation [Manual Air Conditioner]
- Refrigerant Pressure Sensor [Full Auto Air Conditioner]
- Refrigerant Pressure Sensor [Manual Air Conditioner]
Thermostat
Purpose, Function
When the engine coolant temperature is low, the thermostat blocks the engine
coolant passage between the radiator and engine. As a result, because engine
coolant cycles ...
Canister Vent (Cv) Solenoid Valve Inspection
U.S.A. And CANADA
Airflow inspection
1. Disconnect the negative battery cable..
2. Remove the CV solenoid valve..
3. Inspect airflow between the ports under the following conditions.
...
Other materials:
Neutral Switch Inspection
Continuity Inspection
1. Disconnect the negative battery cable..
2. Remove the neutral switch..
3. Inspect for continuity between neutral switch No.1 terminal A and B.
If not as specified, replace the neutral switch No.1..
Specification
Measured conditio ...
Power Window Motor Removal/Installation
Front Power Window Motor
1. Fully lower the front door glass.
2. Disconnect the negative battery cable..
3. Remove the inner garnish..
4. Remove the front door trim..
5. Disconnect the front power window motor connector.
6. Remove bolt A.
7. Remove bolt B.
8. Remove bolt C.
9. R ...
Fuel Injector Inspection
Resistance Inspection
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Disconnect the fuel injector connector.
4. Inspect the resistance between fuel injector terminals A and B.
Fuel injector resistance
1.74—2.04 ohms [20 °C {68 °F}]
...
