Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]

Mazda CX-5 Service & Repair Manual / Engine / Intake / Air Intake Actuator Removal/Installation [Full Auto Air Conditioner]

1. Disconnect the negative battery cable..

2. Remove the glove compartment..

3. Disconnect the air intake actuator connector.


4. Remove the screw, then remove the air intake actuator.

5. Install in the reverse order of removal.

Air Intake Actuator Inspection [Manual Air Conditioner]
1. Connect battery positive voltage to air intake actuator terminal B (or C), connect terminal C (or B) to ground, and then verify that the air intake actuator operates as shown in the table. ...

Air Intake Actuator Removal/Installation [Manual Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the glove compartment.. 3. Disconnect the air intake actuator connector. 4. Remove the screw, then remove the air intake actuator. 5. I ...

Other materials:

Intermediate Shaft Removal/Installation
WARNING: The steering column (EPS motor) temperature increases directly after continuous turning of the steering mechanism which could cause burns if it is touched. Before performing any servicing, verify that the steering column has cooled off. 1. Rotate the steering wheel un ...

Front Sash Molding Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. NOTE: Double-sided adhesive tape has already been attached to the new front sash molding. 1. When installing a new front sash molding, follow the procedur ...

Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the trunk board.. 2. Remove the trunk end trim.. 3. Remove the rear scuff plate.. 4. Remove the trunk side trim.. 5. Disconnect the rear ABS wheel-speed sensor connector. 6. Press the rear ABS wheel-speed sensor tabs and press out the sensor toward the outside of the vehicl ...

© 2016-2026 Copyright www.mcx5.org