Mazda CX-5 Service & Repair Manual: Fuel Tank
Purpose, Function
-
Store fuel safely and supply fuel to the engine.
Construction
U.S.A. and CANADA
-
The fuel tank is installed below the rear seat.
2WD
AWD
-
The fuel tank is made of steel.
-
The following parts are integrated in the fuel tank.
-
Non-return valve
(See NON-RETURN VALVE [SKYACTIV-G 2.0].)
-
Rollover valve
(See ROLLOVER VALVE [SKYACTIV-G 2.0].)
-
Fuel shut-off valve
(See FUEL SHUT-OFF VALVE [SKYACTIV-G 2.0].)
2WD
AWD
Except U.S.A. and CANADA
-
The fuel tank is installed below the rear seat.
2WD
AWD
-
The fuel tank is made of steel.
-
The following parts are integrated in the fuel tank.
-
Non-return valve
(See NON-RETURN VALVE [SKYACTIV-G 2.0].)
-
Rollover valve
(See ROLLOVER VALVE [SKYACTIV-G 2.0].)
2WD
AWD
Fuel Tank Removal/Installation
WARNING:
Fuel is very flammable liquid. If fuel spills or leaks from the pressurized
fuel system, it will cause serious injury or death and facility breakage. Fuel
can also irritate skin ...
High Pressure Fuel Pump Control
Outline
Changes the fuel pressure applied to the fuel injector according to engine
operation conditions to improve engine output and startability.
The PCM determines the fuel pressur ...
Other materials:
Clock Spring Adjustment [Standard Deployment Control System]
1. Set the front wheels straight ahead.
CAUTION:
The clock spring will break if over?wound. Do not forcibly turn the clock
spring.
2. Turn the clock spring clockwise until it stops.
3. Turn the clock spring counterclockwise approx. 2 turns.
4. Align the mark on the clo ...
Rear Side Panel Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
Front Side Frame (Partial Cutting) Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 4 locations indicated by (A) shown in the figure, then remove suspension
mounting reinforcement and outer frame reinforcement.
2. Rough cut location indicated by (B) shown in the figure.
3. Drill the 6 locations indicated by (C) shown in the fig ...
