Mazda CX-5 Service & Repair Manual: Doors/Lids & Hood/Trunk

Body

...

Door Adjustment

1. Measure the gap and height difference between the door and the body. 2. Loosen the door hinge installation bolts and adjust the door. Standard clearance a: 2.8?3.8 mm {0.12?0.14 in} ...

Other materials:

Rear Seat Back Striker Removal/Installation
1. Disconnect the negative battery cable.. 2. Press the push knob to fold the rear seat back. 3. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. 4. Remove the bolts. 5. Remove the rear seat back striker. 6. Install in the ...

Rear Beltline Molding Removal/Installation
CAUTION: Affix protective tape to the position shown in the figure. 1. Fully open the rear door glass. 2. Insert a tape-wrapped flathead screwdriver and then detach the clip A in the direction of arrow (1) shown in the figure. 3. Pull up the rear belt line molding in the di ...

Front Brake (Disc) Removal/Installation
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, add brake fluid, bleed the air, and inspect for fluid leakage.. 4. Depress the brake pedal a few times, rotate the wheel by hand, and verify that the brake does not drag. ...