Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Front Door Latch And Lock Actuator Inspection

Mazda CX-5 Service & Repair Manual / Body / Doors/Lids & Hood/Trunk / Front Door Latch And Lock Actuator Inspection


Actuator/Switch name

Operation

Reference

Front door lock actuator

Electrically switches the lock/unlock of the front doors.

FRONT DOOR LOCK ACTUATOR INSPECTION

Front door lock-link switch

Turns on/off in conjunction with the lock/unlock so that the lock/unlock condition is detected.

DOOR LOCK-LINK SWITCH INSPECTION

Front door latch switch

Turns on/off in conjunction with the latch lever operation so that the front door open/closed condition is detected.

FRONT DOOR LATCH SWITCH INSPECTION

Front key cylinder switch

Turns on/off in conjunction with the lock/unlock of the front door key cylinder so that the key cylinder operation condition is detected.

FRONT DOOR KEY CYLINDER SWITCH INSPECTION


Front Door Key Cylinder Switch Inspection
1. Perform the front door glass preparation.. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inner garnish. b. Front door trim. c. Front door key cylinder. d. ...

Front Door Latch And Lock Actuator Removal/Installation
1. Perform the front door glass preparation.. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Inner garnish. b. Front door trim. c. Inner handle. d. Front door ...

Other materials:

Front Body Control Module (Fbcm) Configuration (Using As Built Data)
NOTE: If the configuration is performed using As-Built data, the set value of the personalization function is reset to the initial value (condition when shipped from factory). Verify the set value with the customer and perform the personalization function setting after performing th ...

Front Combination Light Removal/Installation
WARNING: Incorrect servicing of the discharge headlights could result in electrical shock. Before servicing the discharge headlights, always refer to the service warnings.. NOTE: Fogging or condensation on the inside of the front combination lights may occur due to a n ...

PID/Data Monitor Inspection [Standard Deployment Control System]
1. Connect the M-MDS to the DLC?2. 2. After the vehicle is identified, select the following items from the initialization screen of the M-MDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “RCM”. 3. Select the applicable PID from the PID table. 4. Verify the PID da ...

© 2016-2026 Copyright www.mcx5.org