Mazda CX-5 Service & Repair Manual: Hood Disassembly/Assembly
1. Disassemble in the order indicated in the table.
|
1 |
Fastener |
|
2 |
Hood insulator |
|
3 |
Shroud seaming welt |
|
4 |
Weather strip parting seal |
|
5 |
Hood component |
2. Assemble in the reverse order of disassembly.
Hood Adjustment
Height Difference Adjustment
1. Verify that the height difference between the hood and the body is within
the specification.
Standard clearance
a: 2.7—6.9 mm {0.11—0.27 in}
...
Hood Latch And Release Lever Removal/Installation
Hood Latch
1. Open the hood.
2. Disconnect the negative battery cable..
3. Remove the front bumper..
4. Insert a tape-wrapped flathead screwdriver into the position shown in the
figure.
...
Other materials:
Seat Warmer Control Unit Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
1. Switch the ignition off (LOCK).
2. ...
Hood Latch Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the front bumper..
3. Disconnect the hood latch switch connector..
4. Verify that the continuity is as indicated in the table.
NOTE:
Inspect the continuity when the hood is open and closed.
If the operation as i ...
Torque Box Installation [Panel Replacement]
Symbol Mark
Installation Procedure
1. When installing new parts, measure and adjust the body as necessary to conform
with standard dimensions.
2. Drill holes for the plug welding before installing the new parts.
3. After temporarily installing new parts, make sure the related parts fit p ...
