Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Liftgate Opener System

Outline

Function


CAN signal sending module

Signal name

Instrument cluster

Parking brake lever status signal (MTX)

Via instrument cluster from TCM

Selector lever signal (ATX)

Via instrument cluster from PCM

Vehicle speed signal


Structural view


System wiring diagram


Operation

Operation condition


When all of the following conditions are met, the liftgate opener system operates.

Open operation

1. When the liftgate opener switch is pressed, it turns on (1).

2. When the operation condition of the liftgate opener system is met, the rear body control module (RBCM) turns the transistor on for approx. 0.7 s

(2) and turns on the liftgate release relay.

3. When the liftgate release relay turns on, the liftgate lock actuator operates (3).

4. When the liftgate lock actuator operates, the latch lever is freed and the liftgate lifts up simultaneously via the spring force of the liftgate weatherstrip and stopper rubber, and opens.


Liftgate Opener Switch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Liftgate upper trim. b. Liftgate side trim. c. Liftgate lower trim. d. Liftgate garnish. 3. Remove the liftgate ...

Liftgate Recess Removal/Installation
1. Insert a tape-wrapped flathead screwdriver in the position indicated by the arrow in the figure and detach hooks A. 2. Remove the liftgate recess in the direction of the arrow shown in the ...

Other materials:

Side Member Installation [Panel Replacement]
Symbol Mark Installation Procedure 1. When installing new parts, measure and adjust the body as necessary to conform with standard dimensions. 2. Drill holes for the plug welding before installing the new parts. 3. After temporarily installing new parts, make sure the related parts fit p ...

Tire Pressure Monitoring System Set Switch
Purpose The tire pressure monitoring system set switch is used to initialize the tire pressure monitoring system. Construction, Operation The tire pressure monitoring system set switch is installed to the instrument panel. The tire pressure monitoring sy ...

Tcs Control
Outline The TCS control actuates torque reduction through engine control, as well as using brake control to control traction. NOTE: Engine control: Engine output is lowered by fuel cut and ignition timing control to reduce the traction, preventing driving wheel slip. ...

© 2016-2025 Copyright www.mcx5.org