Purpose/Function
The front and rear door trims are equipped with shock absorbing pads for impulse force relief during a collision.
Construction
Shock absorbing pads are installed inside the front and rear door trims.
Shock absorbing pads absorb the impulse force during a collision.

Door Module Panel
Doors And LiftgateSeat Warmer Control Unit Inspection
WARNING:
Handling a front seat (with built-in side air bag) improperly can accidentally
operate (deploy) the air bag, which may seriously injure you. Read the service
warnings/cautions before handling a front seat (with built-in side air bag)..
CAUTION:
After removing a f ...
Low Fuel Warning Light
Purpose
The low fuel warning light warns the driver that the remaining fuel level
is low.
Function
The instrument cluster calculates the fuel quantity based on the following
CAN signals, and if a remaining fuel amount of approx. 10 L {2.6 US gal, 2.2
Imp gal} (fuel gauge ...
Energy Absorbing Form Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the seal board upper..
3. Remove the front bumper..
4. Insert the flathead screwdriver shown in the figure, push fasteners A for
back side of front bumper reinforcement arrow shown in the figure.
5. Pull the energy-absorbing form in ...