Mazda CX-5 Service & Repair Manual: Liftgate Latch And Lock Actuator Inspection
-
The following actuator and switch are integrated with the liftgate latch and lock actuator.
-
From the actuator/switch name and operation in the following table, select the actuator or switch to be inspected, and perform the inspection following the inspection procedure described in the reference.
|
Actuator/Switch name |
Operation |
Reference |
|
Liftgate lock actuator |
Electrically unlatches the liftgate based on the signal from the rear body control module (RBCM). |
LIFTGATE LOCK ACTUATOR INSPECTION |
|
Liftgate latch switch |
Turns on/off in conjunction with the latch lever rotation so that the liftgate open/closed condition is detected. |
LIFTGATE LATCH SWITCH INSPECTION |
Liftgate Hinge Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Rear scuff plate.
b. Trunk end trim.
c. Trunk side trim.
d. C-pillar trim.
e. D-pillar trim.
f. Liftgate.
3 ...
Liftgate Latch And Lock Actuator Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate lower trim.
3. Disconnect the connector.
4. Remove ...
Other materials:
Differential Oil Temperature Sensor Inspection
WARNING:
Hot differential oil may cause severe burns. Do not perform maintenance while
differential oil is hot.
1. Disconnect the negative battery cable.
2. Disconnect the differential oil temperature sensor connector and remove the
differential oil temperature sensor.
3. Wrap ...
2 6 Brake [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The 2-6 brake locks the rear internal gear and reduction planetary carrier
while in 2GR and 6GR.
Construction
The 2-6 brake consists of the following parts shown in the figure.
The driven plate of the 2-6 brake does not rotate because it is c ...
Engine Coolant Temperature (ECT) Sensor
Purpose/Function
Detects the ECT as basic information for mainly determining the fuel injection
amount.
Detects the ECT and inputs it to the PCM as an ECT signal.
The ECT sensor No.2 is only used for OBD.
Construction
ECT sensor No.1
Installed to the water out ...
