Mazda CX-5 Service & Repair Manual: Door Module Panel
Purpose, Function
-
Styrofoam door module panels have been adopted for reducing vehicle weight.
Construction
-
Styrofoam is applied to the door module panels (shaded areas) during manufacture.
Door Ajar Warning Light
Purpose
The door-ajar warning light notifies the driver that any door or the liftgate
is open.
Function
When the instrument cluster receives any of the following signals sent fr ...
Door Trim
Purpose/Function
The front and rear door trims are equipped with shock absorbing pads for
impulse force relief during a collision.
Construction
Shock absorbing pads are installe ...
Other materials:
Front Drive Shaft Inspection
1. Inspect the connections for any looseness.
If there is any malfunction, tighten or replace the applicable part.
2. Inspect the dust boot for damage and cracks.
If there is any malfunction, replace the applicable part.
3. Move the spline and joint up and down, left ...
Decoration Panel Removal/Installation
CAUTION:
Affix protective tape to the position shown in the figure.
1. Disconnect the negative battery cable..
2. Open the glove compartment.
3. Insert a tape-wrapped flathead screwdriver in the position indicated by the
arrow (1) in the figure and detach clip A.
4. ...
Starter Relay [Skyactiv G 2.0]
Purpose, Function
The starter relay supplies power to the starter by receiving the signal from
the PCM.
Construction
The starter relay is installed to the relay and fuse block.
Operation
The contact point is on when the voltage is supplied to the coil based on
...
