Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Automatic

Transaxle Range Sensor [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The transaxle range sensor detects the position of the manual valve and selector lever. The transaxle range sensor signal is used for automatic shift control, manual ...

Automatic Transaxle Fluid (ATF) Adjustment [Fw6 A EL, Fw6 Ax EL]
CAUTION: Only adjust the ATF level when the ATF temperature is 45—55 °C {113—131 °F}. If the ATF level is incorrect, it could damage the transaxle. Do not add ATF over the spe ...

Other materials:

Engine Coolant Temperature (ECT) Sensor Removal/Installation
WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Drain the engine coolant.. 4. Pull out the evaporati ...

Map Light Bulb Removal/Installation
Front Map Light 1. Disconnect the negative battery cable.. 2. To prevent scratches or damage, affix protective tape to the position shown in the figure. CAUTION: If a flathead screwdriver is inserted into the gap between the front map light and lens, the front map light could inter ...

D Pillar Trim Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk board. b. Trunk end trim. c. Rear scuff plate. d. Trunk side trim. 3. Take the shaded area shown in the figure, and remove the D-pillar trim in the direction of the arrow in the order of (1), (2), (3) wh ...

© 2016-2026 Copyright www.mcx5.org