Chevrolet Spark manuals

Mazda CX-5 Service & Repair Manual: Oil Pump Removal/Installation [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Drivetrain / Transmission/Transaxle / Automatic / Oil Pump Removal/Installation [Skyactiv G 2.0]

WARNING:

CAUTION:

NOTE:

1. Disconnect the negative battery cable..

2. Remove the plug hole plate..

3. Remove the ignition coil/ion sensors..

4. Remove the front under cover No.2..

5. Remove the splash shield..

6. Remove the drive belt..

7. Drain the engine oil..

8. Remove the oil pan..

9. Remove the engine front cover..

10. Remove in the order indicated in the table.

11. Install in the reverse order of removal.

12. Refill with the specified type and amount of the engine oil..

13. Start the engine and confirm that there is no oil leakage.

14. Inspect the oil level..

15. Inspect for the ignition timing and idle speed..

16. Inspect the oil pressure..



1

Oil strainer

2

Oil pump chain tensioner

3

Oil pump driven sprocket

(See Oil Pump Driven Sprocket Removal Note.)

(See Oil Pump Driven Sprocket Installation Note.)

4

Oil pump

(See Oil Pump Installation Note.)


Oil Pump Driven Sprocket Removal Note

1. Temporarily assemble the crankshaft pulley lock bolt, and lock the oil pump against rotation as shown in the figure.


2. Remove the oil pump driven sprocket.

Oil Pump Installation Note

1. Install the oil pump using the following procedure:

a. Temporarily tighten the three bolts

shown in the figure.


b. Tighten the two bolts

shown in the figure to the specified torque.


NOTE:

c. Finally, tighten the bolt shown in the figure to the specified torque.


Oil Pump Driven Sprocket Installation Note

1. Temporarily assemble the crankshaft pulley lock bolt, and lock the oil pump against rotation as shown in the figure.


2. Install the oil pump driven sprocket.

3. Remove the temporarily assembled crankshaft pulley lock bolt.

Not P Position Switch Inspection
NOTE: The not P position switch is built into the selector lever component. 1. Disconnect the negative battery cable.. 2. Remove the front console.. 3. Disconnect the selector lever ...

Oil Pump [Fw6 A EL, Fw6 Ax EL]
Purpose/Function The oil pump generates hydraulic pressure in the oil line of the automatic transaxle together with supplying lubrication to powertrain related parts. Construction ...

Other materials:

Cruise Control
Cruise Control With cruise control, you can set and automatically maintain any speed of more than about 25 km/h (16 mph). WARNING Do not use the cruise control under the following conditions: Using the cruise control under the following conditions is dangerous and could result in loss of ve ...

Front ABS Wheel Speed Sensor Inspection
Sensor Output Value Inspection CAUTION: Resistance inspection using other testers may cause damage to the ABS wheel-speed sensor internal circuit. Be sure to use the M-MDS to inspect the ABS wheel-speed sensor. 1. Switch the ignition to off. 2. Connect the M-MDS to the DLC-2. ...

Liftgate Latch Switch
Purpose, Function The switch turns on/off in conjunction with the rotation of the latch lever, and it detects the open/closed condition of the liftgate by the voltage value which is changed by the rear body control module (RBCM). Construction The switch is turned on/off by ...

© 2016-2025 Copyright www.mcx5.org