Mazda CX-5 Service & Repair Manual: Ignition Coil [Skyactiv G 2.0]

Mazda CX-5 Service & Repair Manual / Electrical / Ignition / Ignition Coil [Skyactiv G 2.0]

Purpose, Function

The ignition coil generates high voltage by electromagnetic induction to discharge the spark plug.

Construction

The ignition coil is installed to the upper part of the spark plug (direct ignition coil).
With the adoption of the direct ignition coil, the ignition system parts have been simplified. As a result, voltage decrease is suppressed and ignition performance for the spark plug is stabilized.
The ignition coil is built into the igniter and ion sensor. For the ion sensor, refer to CONTROL SYSTEM..

Operation

Optimum ignition timing is performed according to the driving conditions by integrating the ignition control function into the PCM.

Fail-safe


DTC	Fail-safe
P0300:00	Limits the intake air amount.
P0301:00 P0302:00 P0303:00 P0304:00	Stops the fuel injection to the misfiring cylinder. Limits the intake air amount.

DTC

Fail-safe

P0300:00

Limits the intake air amount.

P0301:00

P0302:00

P0303:00

P0304:00

Stops the fuel injection to the misfiring cylinder.
Limits the intake air amount.

Ignition Coil Inspection [Skyactiv G 2.0]

Ignition Coil Inspection 1. Perform the spark test and identify the malfunctioning cylinder.. 2. Replace the ignition coil of the malfunctioning cylinder with that of a normal cylinder, and perfo ...

Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

1. Disconnect the negative battery cable.. 2. Remove the plug hole plate.. 3. Remove in the order indicated in the table. 4. Install in the reverse order of removal. 1 ...

Other materials:

Assist Handle Removal/Installation
Removal 1. Insert a tape-wrapped flathead screwdriver into the service hole and remove the assist handle covers. 2. Remove the assist handle in the direction of the arrow (1) and (2), while detach clips. NOTE: Remove the assist handle by shaking it up and down. Install ...

Main Relay Control [Skyactiv G 2.0]
Outline Supplies power to each part by switching the main relay on/off at the optimal timing according to the vehicle conditions. Block Diagram Operation When the ignition is switched ON, the main relay turns on and electrical power is supplied to each sensor and devic ...

Refrigerant Pressure Sensor Inspection [Full Auto Air Conditioner]
1. Install the manifold gauge. 2. Verify the high-pressure side reading of the manifold gauge. 3. Measure the terminal voltage at PCM terminal 2BB, 2AX and 2AJ 4. Using the graph below, measure and verify the terminal voltages at 2AX. 5. Follow the PCM inspection when measuring the other te ...