Purpose/Function
The M position switch detects that the selector lever is in the M position.
The M position switch signal is sent to the TCM via CAN, and is used for manual shift control and engine-transaxle integration control.
Construction
The M position switch is installed to the selector lever.
The M position switch is an on/off type switch.

Operation
When the selector lever is in the M position, the M position switch contact point closes.
By opening and closing the M position switch contact point, the TCM detects that the selector lever is in the M position.

M Position Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
Neutral Switch Removal/Installation [C66 M R]Relay And Fuse Block Middle Cover Disassembly/Assembly
1. Insert a tape-wrapped flathead screwdriver into the service hole in the position
shown in the figure.
2. While pressing the relay and fuse block middle cover tab in the direction
of arrow (1) shown in the figure, pull out the bracket in the direction of arrow
(2) to detach the relay a ...
Ventilator Grille Removal/Installation
Side Ventilator Grille
Driver-side
1. Disconnect the negative battery cable..
2. Remove the switch panel..
3. Insert your hand from the area where the switch panel was installed, remove
the side ventilator grille in the direction of the arrow shown in the figure while
detaching hooks A.
...
Lower Panel Removal/Installation
Driver-side
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Driver-side front scuff plate.
b. Driver-side front side trim.
c. Switch panel.
d. Decoration panel.
e. Shift lever knob (MTX).
f. Front console box.
g. Shift panel.
h. Upper panel.
i. Rear ...