Mazda CX-5 Service & Repair Manual: Intermediate Shaft Removal/Installation
WARNING:
-
The steering column (EPS motor) temperature increases directly after continuous turning of the steering mechanism which could cause burns if it is touched. Before performing any servicing, verify that the steering column has cooled off.
1. Rotate the steering wheel until the joint bolt is in a position in which it can be removed.
CAUTION:
-
Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the intermediate shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spring could be damaged.
2. Lock the adjusting lever.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
|
1 |
Joint cover |
|
2 |
Intermediate shaft (See Intermediate Shaft Removal Note.) (See Intermediate Shaft Installation Note.) |
Intermediate Shaft Removal Note
1. Place an alignment mark across the break between the steering column and the yoke for the intermediate shaft as shown in the figure.
2. Place alignment marks on the steering gear (pinion) and the intermediate shaft as shown in the figure.
3. Remove joint bolt A, then joint bolt B.
4. Remove the intermediate shaft.
Intermediate Shaft Installation Note
1. Place alignment marks on the new intermediate shaft in the same positions as the removed intermediate shaft.
2. Align the alignment marks on the steering column and the steering gear (pinion), which were placed before removing the intermediate shaft, and install the intermediate shaft.
NOTE:
-
Install joint bolt B, then joint bolt A.
3. Verify that the joint bolt B flange is seated in the specified position.
4. Verify that joint bolt A is installed to the groove of the steering gear (pinion).
Initial Learning [Fw6 A EL, Fw6 Ax EL]
Introduction
If the control valve body and oil pressure switch are replaced, always perform
the initial learning. If the initial learning is not completed, engine rev-up
may occur or shif ...
Judder Upon Torque Converter Clutch (TCC) Operation [Fw6 A EL, Fw6 Ax EL]
TROUBLESHOOTING ITEM
Judder upon torque converter clutch (TCC) operation
DESCRIPTION
Vehicle jolts when TCC is engaged.
...
Other materials:
Brake Fluid Pressure Sensor Inspection
1. Switch the ignition to off.
2. Remove the clips.
3. Set the splash shield out of the way.
4. Disconnect the brake pipe from the LF brake hose.
5. Remove the clip.
6. Remove the LF brake hose from the bracket.
7. Detach the brake pipe from the pipe holder.
8. Install the SST ...
Main Silencer
Purpose, Function
Reduces the exhaust noise.
Construction
The main silencer is installed to the vehicle rear, under the trunk compartment.
2WD
AWD
The main silencer consists of the filters, holder, set plates and stiffener.
...
Front Drive Shaft Removal/Installation
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor connector (axle side) ...
