Mazda CX-5 Service & Repair Manual: Down Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The down switch detects the shift down operation of the selector lever.
-
The down switch signal is sent to the TCM via CAN and is used for manual shift control and engine-transaxle integration control.
Construction
-
The down switch is installed to the selector lever.
-
The down switch is an on/off type switch.
Operation
-
When the selector lever is in the shift down position (-), the down switch contact point closes.
-
Based on the opening and closing of the down switch contact point, the TCM detects that the shift down has been operated.
Down Switch Inspection [Fw6 A EL, Fw6 Ax EL]
Continuity Inspection
NOTE:
The down switch is built into the selector lever component.
1. Disconnect the negative battery cable..
2. Remove the front console..
3. Disconnect the se ...
Drive Plate Removal/Installation [Fw6 A EL, Fw6 Ax EL]
1. Remove the transaxle..
2. Remove in the order indicated in the table.
1
Drive plate installation bolts
(See Drive Plate Installation Bolts Removal Note.)
(See ...
Other materials:
Driver and Front Passenger Occupant Classification System
First, please read “Supplemental Restraint System (SRS) Precautions” carefully.
Driver Seat Slide Position Sensor
Your vehicle is equipped with a driver seat slide position sensor as a part of
the supplemental restraint system. The sensor is located under the driver seat.
The sensor ...
Vacuum Pump Inspection
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the
vacuum pump..
2. Install the vacuum gauge as shown in the figure, then check the vacuum.
3. Warn up the engine.
If the pressure is less than the specification, inspect for the following.
Malf ...
Tire Pressure Monitoring System Initialization Procedure
Perform the tire pressure monitoring system initialization when the following
operations have been performed:
Tire pressures have been adjusted
Tires or wheels have been replaced
Tires have been rotated
DSC HU/CM replaced
DSC HU/CM ...
