Mazda CX-5 Service & Repair Manual: Camshaft Position (CMP) Sensor

Mazda CX-5 Service & Repair Manual / Engine / Engine Assembly / Valvetrain, Cylinder Head / Camshaft Position (CMP) Sensor

Purpose/Function

Detects the camshaft speed as basic information for mainly determining the fuel injection timing and ignition timing.
Detects the camshaft speed and inputs it to the PCM as a CMP signal.

Construction

Intake CMP sensor

Installed on the cylinder head.
A GMR element has been adopted as the detecting element for detecting the intake camshaft speed.

Exhaust CMP sensor

Installed on the rear housing.
A GMR element has been adopted as the detecting element for detecting the exhaust camshaft speed.

Operation

Inputs the signal, which fluctuates according to the camshaft speed, to the PCM.

CMP sensor characteristic

Fail-safe

Intake CMP sensor


DTC No.	Fail-safe function
P0340:00	Set the electric variable valve timing control to the maximum cam retard mode.

Exhaust CMP sensor


DTC No.	Fail-safe function
P0365:00	Stops the fuel injection. Stops the ignition.

Camshaft Position (CMP) Sensor Removal/Installation

CAUTION: When replacing the CMP sensor, make sure there is no foreign material on it such as metal shavings. If it is installed with foreign material, the sensor output signal will malfu ...

Camshaft

Purpose, Function The camshaft is rotated by receiving the rotation force of the crankshaft via the timing chain. The valve is opened and closed according to the cam shape at this time. ...

Other materials:

Fuel Filler Lid Opener And Lever Removal/Installation
Fuel-filler Lid Opener 1. Open the fuel-filler lid. 2. Remove the nut. 3. Remove the service hole cover on the trunk side trim. 4. While pressing the tabs of the stopper bracket in the direction of arrow (1) shown in the figure, press it in the direction of arrow (2) to detach it fr ...

Crankshaft, Main Bearing
Purpose, Function The crankshaft converts the reciprocating movement of the piston to a rotational movement via the connecting rod. The main bearing forms an oil film on the outer surface of the crankshaft journal to prevent wear due to sliding. Construction Crankshaft ...

Front Fender Panel Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front bumper. b. Front combination light. c. Front bumper slider. d. Front over fender. 3. Remove bolts A and fasteners B. 4. Remove bolts C. 5. Remove the front fender panel. 6. Install in the reverse ...