Mazda CX-5 Service & Repair Manual: Entertainment
- Antenna Feeder No.1 Inspection
- Antenna Feeder No.1 Removal/Installation
- Antenna Feeder No.2 Inspection
- Antenna Feeder No.2 Removal/Installation
- Antenna Feeder No.3 Inspection
- Antenna Feeder No.3 Removal/Installation
- Audio Amplifier
- Audio Amplifier Removal/Installation
- Audio Pilot®2 Microphone Removal/Installation
- Audio System
- Audio Unit (With Color LCD)
- Audio Unit (Without Color LCD)
- Audio Unit Personalization Features Setting Procedure
- Audio Unit Removal/Installation
- Auxiliary Jack/Usb Port
- Auxiliary Jack/Usb Port Inspection
- Auxiliary Jack/Usb Port Removal/Installation
- Center Roof Antenna
- Center Roof Antenna Inspection
- Center Roof Antenna Removal/Installation
- Coil Antenna
- D Pillar Speaker Inspection
- D Pillar Speaker Removal/Installation
- Entertainment System
- Front Center Speaker Inspection
- Front Center Speaker Removal/Installation
- Front Door Speaker Inspection
- Front Door Speaker Removal/Installation
- Glass Antenna
- Glass Antenna Inspection
- Installation Of Radio System
- Keyless Antenna Removal/Installation
- Keyless Antenna [Advanced Keyless Entry System]
- Keyless Antenna [Keyless Entry System]
- Rear Door Speaker Inspection
- Rear Door Speaker Removal/Installation
- Rear Mount Camera
- Rear Mount Camera Inspection
- Rear Mount Camera Removal/Installation
- Sirius Satellite Radio Unit
- Sirius Satellite Radio Unit Removal/Installation
- Speaker Grille Removal/Installation
- Speaker [With Bose®]
- Speaker [Without Bose®]
- Supplier Identification Procedure [Audio]
- Tweeter Inspection
- Tweeter Removal/Installation
Electronics
...
Antenna Feeder No.1 Inspection
With audio system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Decoration panel.
c. Audio unit.
3. Disconnect antenna feeder No.2.
...
Other materials:
Front Sash Molding Installation
WARNING:
Using a utility knife with bare hands can cause injury. Always wear gloves
when using a utility knife.
NOTE:
Double-sided adhesive tape has already been attached to the new front sash
molding.
1. When installing a new front sash molding, follow the procedur ...
Headliner Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Sunroof seaming welt (with sunroof system).
b. A-pillar trim.
c. Front map light.
d. Sunvisor.
e. Front scuff plate.
f. Rear scuff plate.
g. B-pillar lower trim.
h. Adjust anchor cover.
i. Upper anchor i ...
Transmission/Transaxle Features
Clutch and Manual Transaxle [C66M-R]
A newly developed, C6-type manual transaxle (SKYACTIV-MT) with 6 forward
gears and 1 reverse gear has been adopted.
Automatic Transaxle [FW6A-EL, FW6AX-EL]
A newly developed, FW6A(X)-EL-type electronically controlled automatic transaxle
...
