1. Disconnect the negative battery cable..
2. Remove the side speaker grille..
3. Remove the tweeter..
4. Verify that the resistance between the tweeter terminals is as indicated in the table.

If not as indicated in the table, replace the tweeter.
Without Bose®

With Bose®

Supplier Identification Procedure [Audio]
Tweeter Removal/InstallationSide Turn Light
Purpose
The side turn lights are used to signal vehicles/people at the side of the
vehicle that the vehicle is going to make a right or left turn.
Function
The side turn lights flash according to the operation of the turn or the
hazard switch.
Construction
Side ...
Rear Stabilizer Removal/Installation [2 Wd]
WARNING:
Verify that the rear crossmember is securely supported by a jack. If the
rear crossmember falls off, it can cause serious injury or death, and damage
to the vehicle.
CAUTION:
Performing the following procedures without first removing the rear ABS wheel-spee ...
Clutch Pedal Inspection [C66 M R]
NOTE:
For the clutch pedal inspection, note the following and measure each inspection
location.
Measure the center of the upper surface of the pedal pad for each inspection.
If the distance from the pedal pad to the floor covering is measured,
measure the short ...