Purpose
The air mix actuator moves the air mix door in the A/C unit to adjust the temperature of the air blown from the air vent.
Function
Door open/close function
The air mix actuator drives the motor based on the signals from the climate control unit and moves the air mix door in the HOT or COLD direction.
Door position detection function
The air mix actuator detects the change in the air mix door position using the potentiometer in conjunction with the motor drive, and gives feedback to the climate control unit based on electric signals.

Construction
A potentiometer-type air mix actuator has been adopted.
The air mix actuator is installed to both the driver and front passenger sides in the A/C unit.
Operation
1. The climate control unit calculates the target air mix actuator opening angle (target actuator opening angle) according to the airflow temperature control.
2. The climate control unit detects the current air mix actuator opening angle based on the voltage detected by the potentiometer in the air mix actuator.
3. The climate control unit compares the target actuator opening angle with the voltage from the potentiometer.
4. When the voltage detected by the potentiometer differs from the target actuator opening angle, the climate control unit outputs a motor drive signal to the air mix actuator.
5. When the voltage detected by the potentiometer is equal to the target actuator opening angle, the climate control unit stops the motor drive signal to the air mix actuator.

Fail-safe
Function not equipped.
Air Mix Actuator Removal/Installation [Full Auto Air Conditioner]
Airflow Mode Actuator Inspection [Full Auto Air Conditioner]Low Engine Coolant Temperature Indicator Light (Blue)/High Engine Coolant Temperature
Warning Light (Red)
Purpose
Low engine coolant temperature indicator light (blue)
The low engine coolant temperature indicator light (blue) notifies the driver
that the engine coolant temperature is low and vaporization of the fuel is difficult.
High engine coolant temperature warning light (red)
...
Shift Control Module Removal/Installation [C66 M R]
Removal
1. Shift the shift lever to the neutral position.
2. Remove the plug hole plate..
3. Disconnect the negative battery cable..
4. Remove the air cleaner and air hose as a single unit..
5. Remove the battery and battery tray..
6. Disconnect the control cable from the transaxle.
a. ...
Passenger Side Air Bag Module Removal/Installation [Standard Deployment Control
System]
WARNING:
Handling the air bag module improperly can accidentally deploy the air bag
module, which may seriously injure you. Read the air bag system service warnings
and cautions before handling the air bag module..
NOTE:
When replacing the passenger-side air bag module af ...