Mazda CX-5 Service & Repair Manual: Tweeter Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the side speaker grille..
3. Remove the screws.
4. Pull out the tweeter and disconnect the connector.
5. Install in the reverse order of removal.
Tweeter Inspection
1. Disconnect the negative battery cable..
2. Remove the side speaker grille..
3. Remove the tweeter..
4. Verify that the resistance between the tweeter terminals is as indicated in
the table. ...
Navigation
...
Other materials:
Propeller Shaft Inspection
1. Measure the propeller shaft center runout using the dial gauge.
If it exceeds the maximum specification, replace the propeller shaft as a
single component.
Propeller shaft maximum runout
0.8 mm {0.031 in}
2. Inspect the play and rotation of the joint by turning ...
Rear Scuff Plate Removal/Installation
1. Take the shaded area shown in the figure, detach tab A while pulling the rear
scuff plate in the direction of the arrow (1) shown in the figure, then detach hook
B, clips C, pins D while pulling in the direction of the arrow (2).
2. Take the shaded area shown in the figure, detach tab E whi ...
Front Fog Light
Purpose
By shining light in a wider area in front of the vehicle than the light from
the headlights, visibility during poor weather conditions, such as rain and
fog, has been improved. In addition, the visibility of the vehicle from on-coming
vehicles, pedestrians, and other people h ...
