Mazda CX-5 Service & Repair Manual: Entertainment System
Outline
-
The following entertainment system has been adopted.
-
Audio system (with audio system)
-
Car-navigation system (with car-navigation system)
-
Park assist system (with park assist system)
-
Bluetooth system (with Bluetooth system)
-
An audio unit with integrated AM/FM tuner/MP3/WMA (Windows Media Audio)/AAC (Advanced Audio Coding) applicable CD player in the audio panel.
-
Steering switch has been adopted.
-
A SIRIUS satellite radio antenna which can receive SIRIUS satellite radio has been adopted. (with SIRIUS satellite radio unit)
-
Auxiliary jack/USB port has been adopted.
-
A center roof antenna has been adopted.
-
A glass antenna has been adopted.
-
A rear mount camera has been adopted.
Structural view
D Pillar Speaker Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Trunk board.
b. Trunk end trim.
c. Rear scuff plate.
d. Trunk side trim.
e. D-pillar trim.
3. Disconnect the ...
Front Center Speaker Inspection
1. Disconnect the negative battery cable..
2. Remove the center speaker grille..
3. Remove the front center speaker..
4. Verify that the resistance between the front center speaker terminals is ...
Other materials:
Radiator
Purpose, Function
The radiator disperses the engine coolant heat flowing internally by receiving
against the vehicle while it is driven or air flow produced by the cooling fan.
Construction
The radiator is installed to the front of the engine compartment.
Four mounting ...
Barometric Pressure (Baro) Sensor
Purpose/Function
Detects the BARO as basic information for mainly determining the fuel injection
amount.
Detects the BARO and inputs it to the PCM as a BARO signal.
Construction
Built into the PCM.
A piezoelectric element has been adopted for detecting th ...
Filament Inspection
1. Switch the ignition ON (engine off).
2. Turn the rear window defroster switch on.
CAUTION:
Directly touching the rear window defroster filament with the lead of the
tester could damage it. Wrap aluminum foil around the end of the lead and inspect
the filament by touching it ...
