Mazda CX-5 Service & Repair Manual: Lubrication
- Engine Oil Control
- Engine Oil Level Inspection
- Engine Oil Pressure Warning Light
- Engine Oil Replacement
- Engine Oil Solenoid Valve Inspection
- Engine Oil Solenoid Valve Removal/Installation
- Engine Oil Solenoid Valve
- Front Oil Seal Replacement
- Lubrication System
- Oil Control Valve (OCV) Inspection
- Oil Control Valve (OCV) Removal/Installation
- Oil Control Valve (OCV)
- Oil Cooler Removal/Installation [Fw6 A EL, Fw6 Ax EL]
- Oil Cooler Removal/Installation
- Oil Cooler [Fw6 A EL, Fw6 Ax EL]
- Oil Cooler
- Oil Filter Replacement
- Oil Filter
- Oil Jet Valve
- Oil Pan Removal/Installation
- Oil Pan
- Oil Pressure Inspection
- Oil Pump Removal/Installation
- Oil Pump [Fw6 A EL, Fw6 Ax EL]
- Oil Pump
- Oil Seal (Control Valve Body) Replacement [Fw6 A EL, Fw6 Ax EL]
- Oil Seal (Coupling Component) Replacement
- Oil Seal (Differential) Replacement [C66 M R]
- Oil Seal (Differential) Replacement [Fw6 A EL, Fw6 Ax EL]
- Oil Seal (Side Gear) Replacement
- Oil Shower Pipe
- Oil Strainer [Fw6 A EL, Fw6 Ax EL]
- Oil Strainer
- Rear Oil Seal Replacement
- Oil Pressure Switch Inspection
- Oil Pressure Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
- Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation
NOTE:
Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the
IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1.
1. Disconnect the negative bat ...
Engine Oil Control
Outline
The PCM reduces the oil pump load applied to the engine by controlling the
appropriate engine hydraulic pressure according to the engine operation conditions.
The engine hydr ...
Other materials:
Room Straight Line Dimensions (2) [Dimensions]
Point symbol
Designation
Hole diameter or bolt or nut size mm {in}
A
Front seat belt upper anchor installation
?14 {0.55}
B
Front seat belt upper anchor installation
?14 ...
Shift Pressure Control (Line Pressure Control) [Fw6 A EL, Fw6 Ax EL]
Outline
The TCM drives the pressure control solenoid and adjusts the pressure based
on the accelerator pedal depression amount, vehicle speed, ATF temperature,
and gear shift signal. As a result, line pressure is controlled finely and with
high accuracy according to the engine load c ...
Resistor Inspection [Manual Air Conditioner]
1. Verify that the resistance between the resistor terminals is as shown in the
table.
If there is any malfunction, replace the resistor.
Terminal
Resistance (ohm)
A—D
0.35—0.41
A—B
0. ...
