Mazda CX-5 Service & Repair Manual: Oil Pressure Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
-
The oil pressure switch detects the engagement pressures of the low clutch, 2-6 brake, R-3-5 brake, and the high clutch.
-
The oil pressure switch signal is used for automatic shift control, manual shift control, TCC control, line pressure control, direct electric shift control, and the on-board diagnostic system.
Construction
-
The oil pressure switch contacts the oil passages of the low clutch, 2-6 brake, R-3-5 brake, and the high clutch and is installed to the control valve body.
-
The oil pressure switch is an on/off type switch.
|
Oil pressure switch |
Clutch/brake |
|
|
Oil pressure switch A |
Oil pressure switch No.2 |
2-6 brake |
|
Oil pressure switch No.3 |
R-3-5 brake |
|
|
Oil pressure switch B |
Oil pressure switch No.1 |
Low clutch |
|
Oil pressure switch No.4 |
High clutch |
|
Operation
-
When engagement pressure is supplied to the applicable clutch and brake, the oil pressure switch contact point closes.
-
The TCM detects that clutch engagement pressure is supplied to the applicable clutch/brake by opening/closing the oil pressure switch contact point.
|
Oil pressure switch |
1GR |
2GR |
3GR |
4GR |
5GR |
6GR |
|
Oil pressure switch No.1 |
X |
X |
X |
X |
||
|
Oil pressure switch No.2 |
X |
X |
||||
|
Oil pressure switch No.3 |
X |
X |
||||
|
Oil pressure switch No.4 |
X |
X |
X |
Oil Pressure Switch Removal/Installation [Fw6 A EL, Fw6 Ax EL]
WARNING:
A hot transaxle and ATF can cause severe burns. Turn off the engine and wait
until they are cool.
Always wear protective eye wear when using the air compressor. If the ...
HVAC
...
Other materials:
Steering Gear And Linkage Assembly
CAUTION:
To prevent damage to the steering gear, secure it to the vise using a copper
plate or clean cloth.
1. Assemble in the order shown in the figure.
1
Steering gear
2
Mounting rubber
(See Mounting Rubber Assembly Not ...
Rear Wiper System
Outline
Equipped with continuous, auto-stop, intermittent wiper, and synchronized
washer and wiper operation.
The front body control module (FBCM) performs rear wiper and washer system
fail-safe..
Structural View
System Wiring Diagram
Operation
Continuous operat ...
Cruise Set Indicator Light (Green)
Purpose/Function
Illuminates during the cruise control system operation to inform the driver
that the cruise control system is operating.
Construction
Built into the instrument cluster.
Operation
Illuminates during the cruise control system operation.
...
