Mazda CX-5 Service & Repair Manual: Oil Strainer
Purpose, Function
-
The oil strainer suctions the engine oil in the oil pan using the oil pump vacuum. The engine oil is filtered by the internal filter at that time.
Construction
-
The oil strainer is installed on the suction port of the oil pump.
-
The oil strainer has a filter in the inside.
Oil Strainer [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The oil strainer filters particulate matter in the ATF by passing it through
the built-in filter.
Construction
The oil strainer is a built-in, non-woven fabric ...
Rear Oil Seal Replacement
1. Remove the transaxle..
2. Remove the flywheel (MTX) or the drive plate (ATX)..
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
1
...
Other materials:
Purge Solenoid Valve Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Remove the air cleaner and air hose as a single unit..
4. Disconnect the high pressure fuel pump connector.
5. Disconnect the harness clip as shown in the figure.
6. Remove in the order indicated in the table ...
Push Button Start Inspection
1. Remove the push button start..
2. Verify that the continuity between the push button start terminals is as indicated
in the table.
If the continuity can be verified as indicated in the table, go to the next
step.
If not as indicated in the table, replace the push bu ...
Seat Track Position Sensor Removal/Installation [Two Step Deployment Control
System]
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1min or more..
3. Remove the front driver’s seat..
4. Disconnect the connector from the seat track position sensor by pressing the
connector tab and pulling out the lock lever in the direction of the arro ...
