Mazda CX-5 Service & Repair Manual: Oil Filter
Purpose, Function
-
Engine oil is filtered by passing engine oil through the oil filter element.
Construction
-
The oil filter is installed on the right side surface of the cylinder block.
-
A spin-on type (full-flow type) oil filter has been adopted.
-
The bypass valve is equipped as a detour if the oil filter element becomes clogged.
Oil Filter Replacement
WARNING:
Hot engines and engine oil can cause severe burns. Turn off the engine and
wait until it and the engine oil have cooled.
A vehicle that is lifted but not securely supported ...
Oil Jet Valve
Purpose, Function
The oil jet valve injects engine oil on the back of the piston to cool the
piston.
Construction
The oil jet valve is installed into the cylinder block.
...
Other materials:
M Position Switch [Fw6 A EL, Fw6 Ax EL]
Purpose/Function
The M position switch detects that the selector lever is in the M position.
The M position switch signal is sent to the TCM via CAN, and is used for
manual shift control and engine-transaxle integration control.
Construction
The M position switch is in ...
Mass Air Flow (MAF) Sensor Inspection
Visual Inspection
1. Remove the MAF sensor/IAT sensor No.1..
2. Visually inspect the MAF sensor for the following:
Damage, cracks, soiling
Rusted sensor terminal
Bent sensor terminal
If there is any malfunction, repair or replace the MAF sensor/IAT sensor
...
Brake Hose (Rear) Removal/Installation
1. Remove in the order indicated in the table.
2. Install in the reverse order of removal.
3. After installation, add brake fluid, bleed the air, and inspect for fluid
leakage..
1
Brake pipe
2
Clip
3
Bolt
...
