Mazda CX-5 Service & Repair Manual: Fuel
- After Service Precaution
- Before Service Precaution
- Check Fuel Cap Warning Light
- Direct Fuel Injection System
- Fuel Distributor
- Fuel Draining Procedure
- Fuel Filler Cap Inspection
- Fuel Filler Cap
- Fuel Filler Lid Adjustment
- Fuel Filler Lid Opener And Lever Removal/Installation
- Fuel Filler Lid Opener Cable Removal/Installation
- Fuel Filler Lid Removal/Installation
- Fuel Filler Pipe Removal/Installation
- Fuel Filter (High Pressure) Removal/Installation
- Fuel Injection Control System
- Fuel Injector Inspection
- Fuel Injector Relay
- Fuel Injector Removal/Installation
- Fuel Injector
- Fuel Line Pressure Inspection
- Fuel Pump Control Module Inspection
- Fuel Pump Control Module Removal/Installation
- Fuel Pump Control Module
- Fuel Pump Control
- Fuel Pump Unit Disassembly/Assembly
- Fuel Pump Unit Inspection
- Fuel Pump Unit Removal/Installation
- Fuel Pump Unit
- Fuel Shut Off Valve Inspection
- Fuel Shut Off Valve
- Fuel System
- Fuel Tank Inspection
- Fuel Tank Removal/Installation
- Fuel Tank
- High Pressure Fuel Pump Control
- High Pressure Fuel Pump Inspection
- High Pressure Fuel Pump Removal/Installation
- High Pressure Fuel Pump
- Low Fuel Warning Light
- No.27 Fuel Refill Concerns
- No.28 Fuel Filling Shut Off Concerns
- Quick Release (Fuel System) Connector
- Quick Release Connector Removal/Installation
- Returnless Fuel System
- Fuel Pressure Sensor Inspection
- Fuel Pressure Sensor
- Fuel Pump Relay
- Fuel Tank Pressure Sensor Inspection
- Fuel Tank Pressure Sensor
Turbine/Input Shaft Speed Sensor, Output Shaft Speed Sensor [Fw6 A EL, Fw6 Ax
EL]
Purpose/Function
The turbine/input shaft speed sensor detects the rotation speed of the input
shaft (low clutch drum).
The output shaft speed sensor detects the rotation speed of the ...
After Service Precaution
WARNING:
Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious
injuries or death and damage. When installing the fuel hose, perform “Fuel Leakage
Inspection” ...
Other materials:
Hydraulic Lash Adjuster (Hla) Removal/Installation
WARNING:
A hot engine can cause severe burns. Turn off the engine and wait until it
is cool before servicing.
CAUTION:
If the camshaft is rotated with the timing chain removed and the piston at
the top dead center position, the valve may contact the piston and the engine ...
License Plate Light Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate lower trim.
3. Disconnect the connector.
4. While pressing the license plate light tab in the direction of arrow (1) shown
in the figure, press the l ...
Brakes SST
49 F043 002
Wrench
49 U043 004A
Oil pressure gauge
(Part of 49 U043 0A0A)
49 U043 005
Joint
(Part of 49 U043 0A0A)
49 U043 006
Hose
(Part of 49 U043 0A0A)
...
