Mazda CX-5 Service & Repair Manual: Fuel Tank Pressure Sensor
Purpose/Function
-
The fuel tank pressure sensor detects the fuel tank pressure.
-
Fuel tank pressure sensor is only used for OBD.
Construction
-
The fuel tank pressure sensor is equipped to the charcoal canister.
-
A piezoelectric-type sensor has been adopted.
Operation
-
Inputs the pressure in the fuel tank to the PCM.
Fuel tank pressure sensor characteristic
Fail-safe
-
Function not equipped.
Fuel Tank Pressure Sensor Inspection
Voltage Inspection
NOTE:
The fuel tank pressure sensor cannot be removed as a single unit. When replacing
the fuel tank pressure sensor, replace it together with the charcoal canister
a ...
Intake
...
Other materials:
Side Step Molding Removal/Installation
1. Set the rear over fender aside..
2. Insert a tape-wrapped flathead screwdriver shown in the figure and remove
the clip A in the direction of arrow (1).
3. Slide the side step molding in the direction of the arrow (2) shown in the
figure and remove clips B from side step molding.
4. ...
Wheel Hub Component Removal/Installation [Awd]
CAUTION:
Performing the following procedures without first removing the ABS wheel-speed
sensor may possibly cause an open circuit in the wiring harness if it is pulled
by mistake. Before performing the following procedures, disconnect the ABS wheel-speed
sensor connector (body side) ...
Keyless Antenna [Keyless Entry System]
Purpose
Outputs a request signal and specifies the remote transmitter location.
Function
The keyless antennas output request signals based on the signals from the
start stop unit.
Construction, Operation
Request signals are output by the keyless antenna installed ...
