Mazda CX-5 Service & Repair Manual: Generator Disassembly/Assembly [Skyactiv G 2.0]
CAUTION:
-
Melt the solder quickly, otherwise the diodes (rectifier) and regulator will be damaged by excessive heat.
1. Disassemble in the order indicated in the table.
2. Assemble in the reverse order of disassembly.
|
1 |
Rotor component |
|
2 |
Stator coil component |
|
3 |
Pulley |
|
4 |
Rotor |
|
5 |
Front bearing |
|
6 |
Rear bearing |
|
7 |
Front cover |
|
8 |
Stator coil |
|
9 |
Rectifier |
|
10 |
Regulator component |
|
11 |
Rear cover |
|
12 |
Terminal B component |
Generator Control [Skyactiv G 2.0]
Outline
Idling stability has been improved by optimum control of generator voltage
according to engine operation and electrical load conditions.
The PCM determines the engine operati ...
Generator Inspection [Skyactiv G 2.0]
CAUTION:
Do not apply direct battery positive voltage to generator terminal D, otherwise
it could cause damage to the internal parts (power transistor) of the generator.
Charging syst ...
Other materials:
Crankshaft Position (CKP) Sensor
Purpose/Function
Detects the crankshaft speed as basic information for mainly determining
the fuel injection timing and ignition timing.
Detects the crankshaft speed and inputs it to the PCM as a CKP signal.
Construction
Installed on the side of the cylinder block (ri ...
Antenna Feeder No.1 Inspection
With audio system
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. A-pillar trim (RH).
b. Decoration panel.
c. Audio unit.
3. Disconnect antenna feeder No.2.
4. Verify that the continuity between antenna feeder No.1 terminals is as indicated
in the tabl ...
Room Straight Line Dimensions (2) [Dimensions]
Point symbol
Designation
Hole diameter or bolt or nut size mm {in}
A
Front seat belt upper anchor installation
?14 {0.55}
B
Front seat belt upper anchor installation
?14 ...
