Mazda CX-5 Service & Repair Manual: Fuel Pump Relay
Purpose, Function
-
Controls the fuel pump on/off according to control signals from the PCM.
-
The fuel pump is operated only at engine start or when the engine is running to improve safety.
Construction
-
The fuel pump relay is installed in the relay and fuse block.
Operation
-
The contact point is on when the battery voltage is supplied to the coil based on the signal from the PCM, and the battery voltage is supplied to the fuel pump control module.
-
For the fuel pump control, refer to CONTROL SYSTEM..
Fail-safe
-
Function not equipped.
Fuel Pressure Sensor
Purpose/Function
Detects the fuel pressure in the fuel distributor as basic information for
mainly determining the fuel injection amount.
Detects the fuel pressure in the fuel distri ...
Fuel Tank Pressure Sensor Inspection
Voltage Inspection
NOTE:
The fuel tank pressure sensor cannot be removed as a single unit. When replacing
the fuel tank pressure sensor, replace it together with the charcoal canister
a ...
Other materials:
Switch Panel Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the car-navigation unit. (with car-navigation system).
3. Insert your hand from the lower side of the lower panel (without car-navigation
system) or the area where the car-navigation unit was installed (with car-navigation
system), press t ...
Differential Oil Temperature Sensor
Purpose, Function
The differential oil temperature sensor detects the rear differential oil
temperature based on the resistance of the thermistor, and inputs it to the
AWD CM.
Construction
The differential oil temperature sensor is installed in the rear differential
carr ...
Floor Under Cover Removal/Installation
1. Lift up the vehicle.
2. Remove bolts A.
3. Remove fasteners B.
4. Remove the floor under cover No.1.
5. Remove nuts C.
6. Remove fasteners D.
7. Remove bolts E.
8. Remove the floor under cover No.2.
9. Remove bolts F.
10. Remove the fastener G.
11. Remove the floor ...
