Mazda CX-5 Service & Repair Manual: Fuel Injector Inspection
Resistance Inspection
1. Disconnect the negative battery cable..
2. Remove the plug hole plate..
3. Disconnect the fuel injector connector.
4. Inspect the resistance between fuel injector terminals A and B.
-
Fuel injector resistance
-
1.74—2.04 ohms [20 °C {68 °F}]
-
If not within the specification, replace the fuel injector..
Fuel Injection Control System
Outline
Performs optimum fuel injection according to engine operation conditions.
The PCM determines the engine operation conditions based on the signals from
each input device and d ...
Fuel Injector Relay
Purpose, Function
Supplies power to the PCM for the fuel injector and spill valve control solenoid
valve operation.
Construction
The fuel injector relay is installed in the rela ...
Other materials:
Generator Removal/Installation [Skyactiv G 2.0]
WARNING:
Remove and install all parts when the engine is cold, otherwise they can
cause severe burns or serious injury.
When the battery cables are connected, touching the vehicle body with generator
terminal B will generate sparks. This can cause personal injury, fire, and ...
Solar Radiation Sensor [Full Auto Air Conditioner]
Purpose
The solar radiation sensor detects the sunlight intensity emitted to the
cabin.
Function
The solar radiation sensor converts the detected solar radiation amount to
an electric signal.
Construction
A photodiode (light receiving diode) has been adopted fo ...
Fuel Pressure Sensor Inspection
Voltage Inspection
NOTE:
The fuel pressure sensor cannot be removed as a single unit. When replacing
the fuel pressure sensor, replace it together with the fuel distributor as a
single unit.
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine off or on).
3. ...
