Mazda CX-5 Service & Repair Manual: Fuel Shut Off Valve
U.S.A. And CANADA
Purpose, function
-
Prevents fuel from flowing to the charcoal canister during tight turns or vehicle rollover.
-
Releases evaporative gas to the charcoal canister.
-
While refueling, the fuel shut-off valve closes to prevent a fuel overflow.
Construction
-
The fuel shut-off valve is built into the fuel tank.
-
The fuel shut-off valve consists of float and spring.
Operation
-
While refueling or due to fuel sloshing, the float is flooded with fuel and the floating force causes the valve to close. Also, during a vehicle rollover, the valve closes due to balance between the float gravity and spring.
Fuel Shut Off Valve Inspection
U.S.A. And CANADA
NOTE:
The fuel shut-off valve cannot be removed and inspected as it is built into
the fuel tank.
1. Perform the fuel tank inspection..
If there is any malfu ...
Fuel System
Purpose, Outline
A multiple hole type fuel injector has been adopted which provides higher
fuel injection accuracy for improved fuel efficiency and output.
Piston movement-compressio ...
Other materials:
Automatic Transaxle Removal/Installation [Fw6 Ax EL]
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, disconnect the
front ABS wheel-speed sensor (axle side) and ...
Electric Variable Valve Timing Relay [Skyactiv G 2.0]
Purpose, Function
The electric variable valve timing actuator relay supplies power to the electric
variable valve timing motor/driver after receiving the signal from the PCM.
Construction
The electric variable valve timing actuator relay is installed to the relay
block..
...
Accelerator Pedal, Kickdown Switch [Skyactiv G 2.0]
Purpose, Function
The driver's intentions are transmitted to the PCM via the accelerator pedal.
Kickdown switch (ATX) (Applied VIN (assumed): JM3 KE2*E*D# 148107?)
If the accelerator pedal is depressed carelessly, kickdown control will be
implemented based on the accelera ...
