Mazda CX-5 Service & Repair Manual: Steering
- General
- General Procedures (Steering)
- Precaution
- Steering Abbreviations
- Steering Features
- Steering SST
- Steering Switch
- Steering Switch Inspection
- Steering Switch Removal/Installation
- Linkage, Power
- Electric Power Steering (Eps) Control Module
- Electric Power Steering (Eps) Motor
- Electric Power Steering System
- Eps Control Module Inspection
- Oil Control Valve (OCV) Inspection [Skyactiv G 2.0]
- Oil Control Valve (OCV) Removal/Installation [Skyactiv G 2.0]
- Oil Control Valve (OCV) [Skyactiv G 2.0]
- Power Steering Malfunction Indicator Light
- Pressure Control Valve Inspection [Skyactiv G 2.0]
- Pressure Control Valve [Skyactiv G 2.0]
- Steering Shaft Inspection
- Tie Rod End Inspection
- Tie Rod End Replacement
- Tie Rod Inspection
- Torque Sensor
- Steering Gear And Linkage
- Steering Gear And Linkage Assembly
- Steering Gear And Linkage Disassembly
- Steering Gear And Linkage Inspection
- Steering Gear And Linkage Removal/Installation
- Wheel, Column
- Steering Column And Shaft
- Steering Shaft Inspection
- Steering Wheel And Column Inspection
- Steering Wheel And Column Removal/Installation
- Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
- Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
Seat Belt Inspection
Belt
1. Verify that the belt is installed properly with no twists or kinks.
2. Verify that there is no damage to the seat belt and no deformation of the
metal fittings.
If there is any ma ...
General
...
Other materials:
Air Fuel Ratio (A/F) Sensor Inspection
A/F Sensor Inspection
1. Connect the M-MDS to the DLC?2.
2. Switch the ignition ON (engine on).
3. Warm up the engine to normal operating temperature.
4. Access the following PIDs using the M-MDS..
VSS (Vehicle speed)
RPM (Engine speed)
O2S11 (A/F sensor output current ...
Antenna Feeder No.3 Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Rear scuff plate.
c. B-pillar lower trim.
d. Front seat belt adjusting cover.
e. Front seat belt upper anchor installation bolt.
f. B-pillar upper trim.
g. Rear seat cushion.
h. Trunk ...
Front Combination Light
Purpose
Parts related to the front exterior lights are grouped and housed together
such as the headlight, front turn/parking light, headlight leveling actuator,
wiring harnesses, and connectors.
Function
Each light illuminates or flashes when the light switch, turn switch, ...
