Mazda CX-5 Service & Repair Manual: Door Lock Switch Removal/Installation
Driver's Side
NOTE:
-
The driver's side door lock switch cannot be removed as a single unit because it is built into the power window main switch. If the driver's side door lock switch is replaced, replace the power window main switch..
Passenger's Side
1. Disconnect the negative battery cable..
2. Remove the power window subswitch cover..
3. While pulling the power window subswitch cover in the direction of arrow (1) shown in the figure, pull the door lock switch in the direction of arrow (2) shown in the figure, and detach the door lock switch tabs from the power window subswitch cover.
4. Detach all of the door lock switch tabs from the power window switch cover and remove the door lock switch.
5. Install in the reverse order of removal.
Door Lock Switch Inspection
Driver's Side
1. Disconnect the negative battery cable..
2. Remove the door lock switch..
3. Verify that the continuity is as indicated in the table.
If the continuity is not ...
Entry System
...
Other materials:
Cowl Upper Plate Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 9 locations indicated by (A) shown in the figure.
2. Drill the 2 locations by (B) from the front wheel housing side shown in the
figure.
3. Drill the 2 locations indicated by (C) from the inside shown in the figure.
4. Remove the cowl upp ...
Shift Point Control (Automatic Shift Control) [Fw6 A EL, Fw6 Ax EL]
Outline
The TCM implements auto shift control according to the vehicle speed and
accelerator pedal depression amount while in D position.
When the vehicle is stopped with the selector lever is in the D position
and the brake pedal depressed, the neutral idle control is performed ...
Tie Rod End Inspection
1. Inspect the tie-rod end for damage and the boot for cracks.
If there is any malfunction, replace the tie-rod end.
2. Inspect for excessive play.
If there is any malfunction, replace the tie-rod end.
3. Rotate the tie-rod end five times.
4. Install two nuts to the ba ...
