Mazda CX-5 Service & Repair Manual: Suspension
- General
- General Procedures (Suspension)
- Rear Trailing Link Removal/Installation
- Rear Wheel Hub Bolt Replacement
- Suspension
- Suspension Abbreviations
- Suspension Features
- Wheel Hub Component Inspection
- Wheel Hub Component Removal/Installation [2 Wd]
- Wheel Hub Component Removal/Installation [Awd]
- Front Suspension
- Front Axle
- Front Lower Arm Inspection
- Front Lower Arm Removal/Installation
- Front Shock Absorber And Coil Spring Disassembly/Assembly
- Front Shock Absorber And Coil Spring Removal/Installation
- Front Shock Absorber Disposal
- Front Shock Absorber Inspection
- Front Stabilizer Control Link Inspection
- Front Stabilizer Removal/Installation
- Front Suspension
- Front Wheel Hub Bolt Replacement
- Wheel Hub, Steering Knuckle Inspection
- Wheel Hub, Steering Knuckle Removal/Installation
- Rear Suspension
- Rear Axle
- Rear Coil Spring Removal/Installation
- Rear Drive Shaft
- Rear Drive Shaft Disassembly/Assembly
- Rear Drive Shaft Inspection
- Rear Drive Shaft Removal/Installation
- Rear Lateral Link Removal/Installation
- Rear Lower Arm Removal/Installation
- Rear Shock Absorber Disposal
- Rear Shock Absorber Inspection
- Rear Shock Absorber Removal/Installation
- Rear Stabilizer Control Link Inspection
- Rear Stabilizer Removal/Installation [2 Wd]
- Rear Stabilizer Removal/Installation [Awd]
- Rear Suspension
- Rear Upper Arm Removal/Installation [2 Wd]
- Rear Upper Arm Removal/Installation [Awd]
- Wheels, Tires
- Wheel Alignment Pre Inspection
- Wheel Apron Component Installation [Panel Replacement]
- Wheel Apron Component Removal [Panel Replacement]
- Wheel Balance Adjustment (Aluminum Alloy Wheel)
- Wheels And Tires
- Tire Pressure Monitoring System (TPMS)
- Tire Pressure Monitoring System Initialization Procedure
- Tire Pressure Monitoring System Set Switch
- Tire Pressure Monitoring System Set Switch Inspection
- Tire Pressure Monitoring System Set Switch Removal/Installation
- Tire Pressure Monitoring System Warning Light
- Tire Pressure Warning Alarm
Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing Conditions
(No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
Description
BSM indicator light flashes while not under BSM indicator light-flashing
conditions (no combination switch operation (turn signal switch)
...
General
...
Other materials:
Shroud Upper Reinforcement Removal [Panel Replacement]
Symbol Mark
Removal Procedure
1. Drill the 4 locations shown in the figure.
NOTE:
When drilling the 4 locations shown in the figure, do not drill a hole all
the way through or there could be a problem when installing the new part.
2. Remove the shroud upper reinforcement ...
Filament Repair
1. Clean the filament using isopropyl alcohol.
2. Attach tape to both sides of the filament.
3. Using a small brush or marking pen, apply silver paint.
4. After 2—3 min, carefully remove the tape without damaging the applied
area.
CAUTION:
Do not operate the rear window defro ...
Front Seat Back Trim Removal/Installation
WARNING:
Handling a side air bag improperly can accidentally operate (deploy) the
air bag, which may seriously injure you. Read the service warnings/cautions
in the Workshop Manual before handling the front seat (side air bag integrated)..
If the sliding mechanisms on both ...
