Mazda CX-5 Service & Repair Manual: Cooling

Mass Air Flow (MAF) Sensor/Intake Air Temperature (Iat) Sensor No.1 Removal/Installation

NOTE: Because the IAT sensor No.1 is integrated in the MAF sensor, replacing the IAT sensor No.1 includes replacement of the MAF sensor/IAT sensor No.1. 1. Disconnect the negative bat ...

Coolant Reserve Tank Removal/Installation

1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 1 Wiring harness 2 Hose 3 ...

Other materials:

Passenger Compartment Temperature Sensor Removal/Installation [Full Auto Air Conditioner]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (driver-side). b. Front side trim (driver-side). c. Switch panel. d. Decoration panel. e. Shift lever knob (MTX). f. Front console box. g. Shift panel. h. Upper panel. i. Rear console. ...

Hood Latch And Release Lever Removal/Installation
Hood Latch 1. Open the hood. 2. Disconnect the negative battery cable.. 3. Remove the front bumper.. 4. Insert a tape-wrapped flathead screwdriver into the position shown in the figure. 5. Move the tape-wrapped flathead screwdriver in the direction of arrow (1) shown in the figure t ...

Accessory Sockets
Only use genuine Mazda accessories or the equivalent requiring no greater than 120 W (DC 12 V, 10 A). Front The ignition must be switched to ACC or ON. Center, Rear The accessory sockets can be used regardless of whether the ignition is on or off. CAUTION ●To prevent accessory ...