Mazda CX-5 Service & Repair Manual: Cooling Fan Relay
Purpose, Function
-
The cooling fan relay operates by receiving the signal from the PCM to supply power to the cooling fan motor.
Construction
-
The cooling fan relay is installed on the relay and fuse block.
Operation
-
The contact point is on when the battery voltage is supplied to the coil based on the signal from the PCM, and the battery voltage is supplied to the cooling fan motor.
Fail-safe
-
Function not equipped.
Water Pump
Purpose, Function
The water pump operates by obtaining drive force from the engine via the
drive belt to pump engine coolant.
Construction
The water pump is installed to the eng ...
Thermostat Inspection
1. Remove the thermostat..
2. Visually check that the thermostat valve is closed.
3. Place the thermostat in water.
WARNING:
During inspection, the thermostat and water are extremely hot ...
Other materials:
Buckle Switch Inspection
Driver-side
1. Switch the ignition to off.
2. Disconnect the negative battery cable and wait for 1 min or more..
3. Remove the front seat..
4. Remove the front buckle..
5. Inspect for continuity between the buckle switch terminals using a tester.
If not as indicated in the tab ...
Rear Mount Camera Removal/Installation
CAUTION:
The audio unit communicates with the rear mount camera and records the presence/non-presence
of the rear mount camera when the ignition is switched to ACC or ON (engine
off or on) after connecting the negative battery cable.
If the commander switch is installed wit ...
Map Light Removal/Installation
Front Map Light
1. Disconnect the negative battery cable..
2. Open the sunglasses holder.
3. Remove the screws from the front map light.
4. Move the front map light in the direction of the arrow (1) shown in the figure
and pull out the pin from the bracket.
CAUTION:
Be careful ...
