Mazda CX-5 Service & Repair Manual: Exterior

Light Switch Removal/Installation

NOTE: When removing the light switch, it is necessary to rotate the steering wheel. If the ignition is switched off from ON (engine on) with the driver's door closed, the steering wh ...

Adaptive Front Lighting System (Afs) Control Module Removal/Installation

NOTE: The AFS control module prior to replacement stores the vehicle specification information. A new AFS control module does not store any vehicle specification information. ...

Other materials:

License Plate Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped flathead screwdriver into the clearance between the lens and license plate light shown in the figure. 3. Move the flathead screwdriver in the direction of the arrow shown in the figure, pull out the lens from the license ...

Power Window Subswitch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the cover A. 3. Insert a tape-wrapped fastener remover shown in the figure and remove the tab B in the direction of arrow (1). 4. Slide the power window subswitch cover in the direction of the arrow (2) shown in the figure and re ...

Heated Oxygen Sensor (HO2 S) Heater Control [Skyactiv G 2.0]
Outline Based on the control of the HO2S heater, a stabilized oxygen concentration is detected even at low exhaust temperatures, and feedback control of fuel injection even at cold engine start is made possible for improved cold temperature exhaust emission performance. Both ...