Mazda CX-5 Service & Repair Manual: Storage
- Afs Off Indicator Light
- Air Bag System Warning Light [Standard Deployment Control System]
- Air Bag System Warning Light [Two Step Deployment Control System]
- Automatic Transaxle Warning Light [Fw6 A EL, Fw6 Ax EL]
- Awd Warning Light
- Blind Spot Monitoring (Bsm) Off Indicator Light
- Brake System/ABS Warning Light
- Bsm Indicator Light Does Not Flash While Under Bsm Indicator Light Flashing Conditions (With Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
- Bsm Indicator Light Flashes While Not Under Bsm Indicator Light Flashing Conditions (No Combination Switch Operation (Turn Signal Switch)) [Blind Spot Monitoring (Bsm)]
- Charging System Warning Light
- Check Fuel Cap Warning Light
- Cruise Main Indicator Light (Amber)
- Cruise Set Indicator Light (Green)
- Door Ajar Warning Light
- Engine Oil Pressure Warning Light
- Front Fog Lights Indicator Light
- Gear Position Indicator [Fw6 A EL, Fw6 Ax EL]
- Headlight High Beam Indicator Light
- Key Warning Light (Red)/Key Indicator Light (Green)
- Lights On Indicator Light
- Lights On Reminder Warning Alarm
- Low Engine Coolant Temperature Indicator Light (Blue)/High Engine Coolant Temperature Warning Light (Red)
- Low Fuel Warning Light
- Master Warning Light
- Panel Light Control Indicator Alarm
- Power Steering Malfunction Indicator Light
- Seat Belt Warning Alarm
- Seat Belt Warning Light
- Security Indicator Light
- Shift Position Indicator Light [Fw6 A EL, Fw6 Ax EL]
- Tcs Off Switch, Tcs Off Indicator Light
- Tcs/DSC Indicator Light
- Tire Pressure Monitoring System Warning Light
- Turn And Hazard Indicator Alarm
- Turn Signal/Hazard Warning Indicator Lights
Key Cylinder Switch
Purpose
The switch turns on/off in conjunction with the front door key cylinder lock/unlock
and the rear body control module (RBCM) detects the key cylinder operation condition
by the cha ...
Afs Off Indicator Light
Purpose
The AFS OFF indicator light notifies the user that the AFS is stopped or
a malfunction occurs in the AFS.
Function
The AFS OFF indicator light illuminates when the AFS i ...
Other materials:
Side Step Molding Removal/Installation
1. Set the rear over fender aside..
2. Insert a tape-wrapped flathead screwdriver shown in the figure and remove
the clip A in the direction of arrow (1).
3. Slide the side step molding in the direction of the arrow (2) shown in the
figure and remove clips B from side step molding.
4. ...
Forced Ignition On
NOTE:
In order to perform a forced ignition ON, the M-MDS is necessary. If the
servicing is being done outside of an Authorized Mazda dealership, contact an
Authorized Mazda dealership for instructions.
The forced ignition ON procedure forces a power supply to each part when
...
Relay And Fuse Block
Purpose
Relays and fuses used by each system are grouped and housed together for
smooth inspection and replacement servicing.
Function
Relays and fuses used by each system are grouped and housed together.
Construction
Installed in the engine compartment.
...
