Mazda CX-5 Service & Repair Manual
- Vehicle General
- How To Use This Manual
- Abbreviations
- Body And Accessories SST
- Front Wiring Harness Protector Removal/Installation
- Identification Number Locations
- Jacking Positions, Vehicle Lift (2 Supports) And Safety Stand (Rigid Rack) Positions
- Personalization Features
- Pre Delivery Inspection
- Push Button Start Inspection
- Push Button Start Removal/Installation
- Sae Standards
- Service Cautions
- St 001/12 Special Service Tool Shipment January 2013
- Units
- Vehicle Identification Number (VIN) Code
- Accessories
- Body
- Doors/Lids & Hood/Trunk
- Body Exterior, Frame
- Glass & Windows
- Horn
- Driver Info & Control
- Body Interior
- Lighting & Horn
- Mirrors
- Roof - Fixed, Leisure
- Seats
- Wipers, Washers
- Brakes
- Drivetrain
- Electrical
- Engine
- General
- Belts, Hoses, Pulleys
- Control
- Cooling
- Emissions
- Engine Assembly
- Exhaust & Emissions
- Forced Induction
- Fuel
- Intake
- Lubrication
- HVAC
- Restraints
- Restraints
- Restraints SST
- Adjuster Anchor Removal/Installation
- Air Bag Module And Pre Tensioner Seat Belt Deployment Procedures [Standard Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Deployment Procedures [Two Step Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Standard Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures [Two Step Deployment Control System]
- Buckle Switch Inspection
- Front Buckle Removal/Installation
- Front Seat Belt Removal/Installation
- Lap Pre Tensioner Seat Belt [Two Step Deployment Control System]
- Pre Tensioner Seat Belt [Standard Deployment Control System]
- Pre Tensioner Seat Belt [Two Step Deployment Control System]
- Rear Buckle Removal/Installation
- Rear Seat Belt Removal/Installation
- Seat Belt
- Seat Belt Inspection
- Steering
- Suspension
Personalization Features
Personalization Features
...
Vehicle General
...
Other materials:
Clutch Release Cylinder Removal/Installation [C66 M R]
CAUTION:
Do not allow clutch fluid to get on a painted surface. Clutch fluid contains
properties which can dissolve the paint. If clutch fluid gets on a painted surface,
wash it off with water immediately and wipe the area off completely.
1. Remove the front under cover No.2..
...
Transfer Removal/Installation [Fw6 Ax EL]
CAUTION:
Performing the following procedures without first removing the front ABS
wheel-speed sensor may possibly cause an open circuit in the harness if it is
pulled by mistake. Before performing the following procedures, disconnect the
front ABS wheel-speed sensor (axle side) and ...
Windshield Wiper And Washer Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Column cover.
b. Wiper and washer switch.
3. Use a tester to measure and verify that the continuity between the windshield
wiper and washer switch terminals is as indicated in the table.
If the continu ...
